New

CNC Shield + 4 DRV8825 Driver Kit For Arduino

Special Price SDG 1050.00

Item Code: #54

Availability: In stock

Condition: New

Quick Overview

1. Uses removable A4988 or DRV8825 compatible stepper drivers.
2. The extension board can be used for carving machine, 3 d printer driver expansion board
3. GRBL 0.8 compatible. (Open source firmware that runs on an For Arduino UNO that turns G-code commands into stepper signals)
4. PWM Spindle and direction pins,4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z
 or do a full 4th axis with custom firmware using pins D12 and D13)
5. Compact design. Stepper Motors can be connected with 4 pin molex connectors or soldered in place.
6. Please note that this is an unassembled kit and Basic soldering skills are needed.


DRV8825 Stepper Motor Driver:
The module has an interface pinout is almost the same with A4988 stepper motor drive carrier,
so that it can be used as a higher performance in a pull-down menu the plates replaced in many applications.
DRV8825 features an adjustable current limit, overcurrent and overtemperature protection, six micro-resolution (down 1/32-step).
It uses 8.2 - 45V, can provide up to about 1.5 per phase no heat sink or forced air flow (rated up to 2.2 per volume sufficient additional cooling).

Features:
• Simple step and direction control interface
• The interface can connect directly with 3.3V and 5V systems
• Support over-temperature thermal shutdown, over-current shutdown and under-voltage lockout
• Support short-to-ground and shorted-load protection
• Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
• 4-layer, 2 copper PCB for improved heat dissipation
• Adjustable current control support you to set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
• Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
• 45V maximum supply voltage
• Built-in regulator (needed external logic voltage supply)

Package include:
1 x CNC Shield Board
4 x DRV8825 Stepper Motor Driver